Guides6 min read

MFK car inspection in Ticino: what is checked and how to prepare

MFK car inspection (collaudo) in Ticino: what is usually checked (lights, tyres, brakes, rust, leaks), how to prepare and why a clean underbody helps.

In short
  • The inspection generally checks safety and compliance: lights, tyres, brakes, steering, rust, leaks, noise and exhaust emissions.
  • Many problems can be spotted beforehand with a check at home: bulbs, tyres, warning lights, documents.
  • A clean underbody and engine bay let the inspector see clearly and do not hide leaks.

The notice for your vehicle inspection (known as the collaudo in Ticino and as the MFK in German-speaking Switzerland) always arrives at the least convenient moment. In Ticino periodic vehicle inspections are organised by the Sezione della circolazione, the cantonal road traffic office, which sends a notice with the date and location. Preparing properly reduces the risk of having to come back for a second inspection and losing more time. In this guide you will find the points that are usually checked, a practical checklist and some tips for arriving with peace of mind.

An important caveat: the precise rules (deadlines, documents to bring, fees, locations and opening hours) are set by the authorities and may change. Always check the official information from the Sezione della circolazione of the Canton of Ticino before you go.

When the inspection is due

In Switzerland cars undergo periodic inspections at intervals set by law, which depend on the age of the vehicle. The notice is sent by the canton; in some cases you can bring the appointment forward or move it, following the instructions given in the notice itself.

If you have just bought a used car, also check the date of the last inspection: it can affect the price and how long registration takes.

What is usually checked

The inspector checks that the vehicle is safe and matches the details in its vehicle registration document (licenza di circolazione). In general, the main points are:

  • Lights and signals: dipped and main beam headlights, headlight alignment, indicators, side lights, brake lights, reversing lights, rear fog light, number plate light.
  • Tyres and wheels: tread depth, sidewall damage, uneven wear, sizes matching the registration document.
  • Brakes: effectiveness, balance between left and right, parking brake, condition of discs and hoses.
  • Steering and suspension: play, boots, shock absorbers, bushes.
  • Bodywork and chassis: structural rust, sharp edges, fixings.
  • Leaks: oil, coolant, brake fluid, fuel.
  • Noise and exhaust: silencer in good condition, noise levels and exhaust emissions within limits.
  • Glass, mirrors and wipers: cracks in the field of vision, effective wiper blades, working washers.
  • Compliance: chassis number, registered modifications, type-approved accessories.

The checklist to do at home

Many referrals to a second inspection are caused by details that can be sorted out in a few minutes.

  1. Switch on all the lights and walk around the car, ideally with someone helping you check the brake lights. Replace any blown bulbs.
  2. Check the tyres: tread, cuts, bulges, pressure. In Switzerland the legal minimum is 1.6 mm, but if your tyres are close to the limit it is worth considering replacing them beforehand. If it is time for the seasonal change, make the most of it: you can book a mobile tyre change.
  3. Look at the dashboard: a warning light that stays on (airbag, ABS, engine) is often a reason for a referral.
  4. Check the fluid levels and, after the car has been parked overnight, look underneath for stains.
  5. Wipers and washers: blades that do not leave streaks, washer reservoir full.
  6. Windscreen: cracks in the driver's field of vision must be repaired or the glass replaced.
  7. Documents: the vehicle registration document and any documents requested in the notice.

If you have doubts about the brakes, suspension or rust, it is better to have the car checked by a garage before the inspection.

Want the exact price for your car?

The calculator gives you a price in 30 seconds based on model, service and area.

Why a clean underbody helps

During the inspection the inspector looks at the car from below, on a lift or over a pit. If the underbody is covered in mud, salt and grime, they can see the brake lines, suspension mountings and any rust less clearly. The same goes for the engine bay: a layer of oily dirt makes it hard to tell whether there is an active leak or just an old residue.

A car that is clean underneath and in the engine bay:

  • allows a quicker, clearer inspection, with no doubt about what is dirt and what is a defect;
  • shows whether a leak is real: after cleaning, a new drop is immediately visible;
  • reveals rust that needs treating, so you can act before it becomes structural;
  • gives the inspector the impression of a well-kept car. This does not change the inspection criteria, but it does no harm.

But be careful: cleaning does not mean hiding. Washing the engine bay just before the inspection to mask a leak is pointless, because the problem reappears and safety comes first. The aim is to show the real condition of the car clearly.

The engine bay must be cleaned methodically: no high-pressure washer on connectors, control units and the alternator, gentle products and thorough drying. It is one of the jobs we do as part of our MFK inspection preparation, together with washing the underbody and wheel arches.

The inspection after winter

In Ticino many inspection notices fall in spring, after months of salted roads. Salt builds up exactly where the inspector looks: the underbody, wheel arches and suspension mountings. A full valet including the lower parts of the car, a few weeks beforehand, helps both for the inspection and to limit corrosion. We also cover this in our guide on how to protect your car from road salt in winter.

If the car does not pass

If the inspector finds defects, you will be told what needs repairing and by when the vehicle must be presented again, according to cantonal rules. For minor bodywork damage you can consider smart repair; for mechanical work, contact your usual garage. If you do not have time to take the car in, there is also our pick-up and delivery service.

The Riflesso teamMobile car detailing in Ticino, for sports and luxury cars.
FAQ

Before you book.

Can't find the answer? Message us on WhatsApp.

Do I have to wash the car before the inspection?

It is not a legal requirement, but a clean car, especially underneath and in the engine bay, lets the inspector check it more effectively. In any case, check the notice for any specific instructions.

What are the most common reasons for a referral?

In general: lights not working, worn or damaged tyres, warning lights on the dashboard, ineffective brakes, leaks and rust. Many of these can be spotted with a check at home.

Can I clean the engine bay with a pressure washer?

It is best to avoid high pressure on electrical components and connectors. You need gentle products, little water and thorough drying.

Where can I find official information on vehicle inspections in Ticino?

On the website and in the documents of the Sezione della circolazione of the Canton of Ticino, which give up-to-date deadlines, locations, documents and fees.

WhatsApp